Sample Data - HOBO U30 Station Compressed Air Flow and Compressor Power Monitoring

Attached is a screenshot from a HOBOware data file from a HOBO U30 Station that recorded compressed air flow in SCFM and compressor power in kW. Products used were: U30-NRC Veris...

Sample Data - HOBO U12-012 Temp, RH, Light, and CO2

Attached is a screenshot of a HOBO U12-012 Temp/RH/Light/External Input data file with the Telaire 7001 CO2 sensor connected to the external input.

Sample Data - HOBO RX3000 - RXMOD-A1 - Judd Snow Depth Data from HOBOlink

Attached is a screenshot from HOBOlink depicting data recorded by a HOBO RX3000 station that was connected to the Judd Snow-Depth Sensor. The data was recorded during a snow event over a few days...

HOBOware Pro's Growing Degree Days Assistant

Learn how to use HOBOware Pro's Growing Degree Days Data Assistant

Sample Data - HOBO UX90 & Electric Hot Water Heater Runtimes

Attached is a screenshot from HOBOware that depicts a data file generated from a HOBO UX90-001 Runtime logger connected to a CSV-A8 current switch that was clamped onto one of the 240VAC lines...

Sample Data - HOBO U20-001-XX - Multiple Intervals Example

Attached is a screenshot of a data file recorded by a HOBO U20-001-XX with multiple intervals configured. Up to eight (8) intervals can be programmed into the U20 at time of launch. Changes from one...

`-888.88 Data Values

Problem: My Smart Sensor data shows a -888.888 for a good portion of the data file. -888.888 means that the logger cannot get a response from the Smart Sensor (after launch) Likely reasons:...

Sample Data - Plug Load Data and Power Loss

Attached is a screenshot of a data file from a HOBO UX120-018 Plug Load Logger that shows you what happens if AC power is lost during deployment. Because the logger operates on battery power when AC...

How to Analyze HOBO UX90-005 & UX90-006 Light/Occupancy Data

See how to use Onset's HOBOware Pro software to plot and analyze light and occupancy data from the HOBO UX90-005 and UX90-006 data logger.

How do I add or remove series or events from the graph?

Tap the menu icon at the top of the graph and then enable or disable the sensors, statistics, and events you wish to show or hide on the graph. Tap the menu icon again when you are done.

How to use the HOBO U-DTW-1 Waterproof Shuttle with HOBOware Pro

Learn how to properly use the HOBO Waterproof Shuttle with Onset's HOBOware Pro software.

Resetting the password on an MX logger

MX1101 MX1102 Simultaneously press both the Start/Stop button and the Alarm/Stats button on the top of the logger for three seconds or tap Reset to Factory Default on the Set Logger Password...